Call

 

Listed here in the next paragraph you can locate a lot of quality advice when it comes to What Would Cause My Electric Water Heater to Stop Working?.

Numerous modern houses take advantage of an electric hot water heater for their furnace, because of its convenience as well as convenience of use. However, similar to any other electric appliances, troubles might occur with its usage, all of a sudden. It can be actually irritating to get up to a cold shower rather than a hot one or having your bathroom with water that isn't hot enough and even also hot. Whatever the instance may be, water heater troubles can be rather aggravating. Fortunately, we've made a listing of feasible solutions to your hot water heater concerns. There are a variety of aspects that can cause most of these troubles, it could be a concern with the power supply, the electric heating element, or the thermostat. Before doing anything, ensure you shut off the primary power supply for safety. Whatever the trouble is, getting it dealt with should not posture too much of a problem if you adhere to these actions:

 

Call An Expert:

If after changing all faulty components as well as resetting your temperature, the water heater still isn't working, you might require to get in touch with a specialist plumber for a professional viewpoint. The trouble with your heater could be that the hot and cold taps have been switched or it might be undersized for the quantity of warm water needed in your home. Whatever the situation may be, an expert plumber would help resolve the issue.

 

Inspect Your Power Supply:

As fundamental as this might seem, it is very required. Without sufficient power, your hot water heater will not operate. So the first thing to do when your water all of a sudden stops working is to verify that it isn't a power trouble. Inspect if the fuse is burnt out or the breaker tripped. If the breaker is the concern, just turn it on and off again. Replace any kind of damaged or worn-out fuse. Check the home appliance with power after these changes to see if it's currently functioning.

 

Inspect Your Thermostat:

If your water heater still isn't working or the water coming out isn't warm sufficient, you may require to check the temperature setups on your top thermostat. Make sure the breaker is turned off prior to doing anything. Open the accessibility panel and also press the red button for temperature level reset over the thermostat. This must assist warm the water. Turn the circuit breaker back on and also examine if the problem has actually been settled.

 

Examine the Heating Element in the Water Heater:

If it's not a power trouble, after that try taking a look at your heating element if it is still functioning. Examine each of your burner to ensure the problem isn't with any of them. If any of them is damaged, replace that part and after that check whether the hot water is back on.

 

Conclusion

Water heater troubles are not always major. Much of them result from minor issues like a blown fuse or worn-out burner. Changing the faulty parts should suffice. However, if you are still incapable to fix the trouble, give a call to your local plumber to come to get it dealt with.

 

Common Reasons Why Your Hot Water Heater Isn’t Working

 

Water Gets Too Hot

 

Ouch! You wanted a hot shower, not boiling! If you have a newer model electric water heater, your water heater works with a thermostat (actually, two thermostats). If this thermostat has been jostled — or purposely reset — by someone in your home, the water flow will be much hotter than you expected.

FIX: Adjust the thermostat to a more moderate setting for producing hot water. Forty-nine degrees Celsius is recommended to prevent scalding.

 

Water Doesn’t Get Hot

 

This is the opposite of the previous problem, but it’s almost as bad. Your flow of hot water is merely lukewarm or even incoming cold water. Once again, an incorrect thermostat setting, or a faulty thermocouple in a gas water heater, could be to blame. Another explanation might be that there’s no power to the water heater (in the case of an electric heater) or the pilot light has gone out (if you have a gas unit).

FIX: Adjust your thermostat as necessary. If that doesn’t do the trick, check the power supply. Another possibility is the replacement of a damaged thermocouple in gas water heaters.

 

Leaking Water Heater

 

A leaking water heater (a sign may be low hot water pressure, or not enough hot water to shower) might be a reason to push the panic button… but first, take a few minutes to check where the leakage is coming from. Leaks near the top of the heater tend to indicate a problem with a valve, which won’t need a major repair. However, a leak from the water heater base is more serious.

FIX: You may need a qualified plumber to replace your drain valve or TPR (temperature pressure relief) valve. When your water heater is leaking from below, your plumber might be able to fix it if you call them soon enough. Otherwise, you will need to have a new water heater installed.

 

Noisy Water Heater

 

Sometimes your water heater might make some peculiar noises, loud enough to compete with your singing in the shower. Are these a cause for alarm? It depends on exactly what kind of sounds you are hearing. Sizzles and rumbles are both red flags, indicating a heavy sediment buildup in your hot water tank that might cause a breakdown in the near future. In addition, banging is a sign of a water hammer, which can lead to serious damage to your pipes.

FIX: To stop sizzling or rumbling, turn off the tank and have it flushed by a reliable plumbing company ASAP. Ask your plumber to install a water hammer arrestor to quiet down the banging and save the pipes.

 

Pilot Light Keeps Going Out

 

Many pilot lights go out once in a while, but when your water heater pilot light keeps going out continually, it’s a problem. And the chances are good that that problem stems from either a shortage of combustible air or a malfunctioning thermocouple.

FIX: Increase the air supply around your water heater by cleaning dust and lint off the appliance and clearing any clutter from the area around it. A bad thermocouple will require expert plumbing repair and is more than basic gas water heater troubleshooting.

 

Water Smells Bad

 

The water from your residential plumbing pipes should smell neutral. If it has a strong unpleasant odour, something’s wrong. To check whether your water heater is at fault, turn on a hot water faucet and let it run for a few minutes. And, yes, use your nose to determine exactly what you are smelling.

FIX: For a garlicky odour, relight the pilot light on your water tank. When you detect the scent of garbage, you’ll need a professional plumber to flush the hot water tank and possibly replace the anode rod. A strong smell of rotten eggs could signal a hazardous gas leak; turn off the gas supply if possible, get everyone out of your house, and make an emergency call to the gas company.

 

Water Looks Brown Or Rusted

 

The first thing to do is ask yourself, “Is the brown, rusty-looking water coming only from my hot water taps?” If the answer is yes, then most likely, either the anode rod or the water heater interior is starting to rust, especially if your hot water heater is nearing the end of its life expectancy. (A “no” answer means the issue does not originate from the hot water heater but rather from the water supply.)

FIX: Contact a plumber to inspect the water heater. If you catch the problem quickly enough, it might be fixable. Otherwise, you’ll need a water heater replacement. Consider installation of an efficient new tankless water heater.

https://www.huskyair.com/blog/hot-water-heater-isnt-working/

 

Hopefully you liked our part on How to Troubleshoot and Repair an Electric Water Heater. Thank you so much for spending some time to read our article. Are you aware of anybody else who is looking into How to Troubleshoot and Repair an Electric Water Heater? Be sure share it. We truly appreciate reading our article about No Hot Water — Water Heater Repair.

Need fast plumbing resolution? Call.